When you hear a strange noise coming from the front of your car, the wheel bearing hub assembly front may be the culprit. In that case, you may need to replace the assembly urgently to prevent further damage to your car.
Wheel bearing hub assembly is an essential component that connects the wheel to the car’s chassis and enables the wheel to spin freely.
In this blog, we will provide all the knowledge you need about installing a wheel-bearing hub assembly in the front of your vehicle. So, let’s follow the steps!
Step One: Removing the assembly
Before you begin, collect all the necessary tools, including a hub puller, brake caliper, screwdrivers, and pliers. Then, please turn off your engine and secure your car on jack stands to avoid accidents.
- First, remove the brake assembly, including the rotor and caliper, to access the hub.
- Next, take off the ABS (Anti-lock Braking System) sensor from the hub.
- Please make sure you do this gently so you don’t damage it.
- Finally, remove the hub by using a hub puller tool.
Step Two: Cleaning and preparation
It’s important to note that the hub assembly you remove may have scored or damaged areas that could cause problems. These areas should be cleaned, sanded, or filed to ensure smoothness. Wipe away any dust or debris on the hub bolts and mounting surfaces with a clean cloth.
Additionally, inspect the bearings and seal for any signs of visible wear, rust, or discoloration. Finally, use a new bearing grease to lubricate both bearings properly.
Step Three: Installing the Assembly
Once you have cleaned and prepared the hub assembly, it’s time to reinstall the hub.
- Start by inserting the wheel bearing and seal into the assembly. Make sure they fit tightly so that they don’t move around.
- Then, mount the hub onto the spindle, making sure it fits perfectly before tightening the bolts.
- Next, install the ABS sensor back onto the hub and connect the electrical connector.
- Finally, reinstall the brake assembly, including the caliper and rotor.
Step Four: Post-installation
After installation, taking your car for a short drive is essential to ensure everything works correctly. Listen carefully for strange noises, and check the brakes and ABS system.
Consider taking the car for a wheel alignment check to ensure the tires wear evenly. Then, if everything looks and sounds fine, you can conclude the installation process. Make sure to test the ride before finalizing everything.
Conclusion
Installing a wheel-bearing hub assembly can be overwhelming for many car owners, but knowing how to install the replacement properly is essential. In addition, when you notice unusual noises or vibrations from your vehicle, taking immediate action is vital.
By following the above steps, you can easily replace your wheel bearing hub assembly and save money on additional repairs. Remember, always take safety precautions when working on your car, and feel free to seek professional help if you need more confidence in handling the job.
